Garage door won't close: sensor repair in Glen Rock

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (551) 266-2519

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Glen Rock repairs the sensors and re-tests the opener's safety system.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Glen Rock

Glen Rock is a compact borough with two train stations and houses mostly from the 1920s to the 1950s. Around Rock Road and the station area, and in Prospect Park, garages are detached, at the back of narrow lots, and used as much for storage as for cars. On the northern and southern streets, capes and colonials have single attached garages where the sensors sit beside the tire track. On the west side, slightly larger lots have two-car garages with original brackets. The borough's tree canopy is dense, and leaves blown against the door each fall are the main seasonal cause of a door that will not stay down.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Glen Rock

  • Southern streets: Near the Fair Lawn line, with post-war homes and attached garages.
  • West side: Toward Hawthorne along Lincoln Avenue, with mixed older and rebuilt homes.

See the full Glen Rock service area.

Leave the door where it is and call.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 266-2519
Call (551) 266-2519